Outputs For Signalling - ABB REG650 Technical Manual

1MRK 502 034-UEN -
17.3.2
Technical Manual
Terminal Description
X331-4
X331-5 Power output 3, normally open
X331-6
Table 453: Output contacts X336, 6U half 19"
Terminal Description
X336-1 Power output 1, normally open
X336-2
X336-3 Power output 2, normally open
X336-4
X336-5 Power output 3, normally open
X336-6

Outputs for signalling

Signal output contacts are used for signalling on starting and tripping of the IED.
On delivery from the factory, the start and alarm signals from all the protection
stages are routed to signalling outputs. See connection diagrams.
Each signal connector terminal is connected with one 0.5...2.5 mm
2
two 0.5...1.0 mm wires.
Table 454: Output contacts X307, 6U half 19"
Terminal Description
X307-13 Signal output 1, normally open
X307-14
X307-15 Signal output 2, normally open
X307-16
X307-17 Signal output 3, normally open
X307-18
Section 17
IED physical connections
PCM600 info
Hardware module Hardware channel
instance
BIO_5 BO3_PO
PCM600 info
Hardware module Hardware channel
instance
BIO_6 BO1_PO
BIO_6 BO2_PO
BIO_6 BO3_PO
2
wire or with
PCM600 info
Hardware module Hardware channel
instance
PSM_102 BO7_SO
PSM_102 BO8_SO
PSM_102 BO9_SO
527