Chrysler 2005 Crossfire SRT6 Service Manual page 1649

ZH
WIRE
STANDARD PROCEDURE
WIRE SPLICING
When splicing a wire, it is important that the correct gage be used as shown in the wiring diagrams.
1. Remove one-half (1/2) inch of insulation from each wire that needs to be spliced.
2. Place a piece of adhesive lined heat shrink tubing on one side of the wire. Make sure the tubing will be long
enough to cover and seal the entire repair area.
3. Place the strands of wire overlapping each other
inside of the splice clip(1).
4. Using crimping too(1)l, Mopar p/n 05019912AA,
crimp the splice clip and wires together.
8W-01 WIRING DIAGRAM INFORMATION 8W - 01 - 13