Road Tire Installation; Jump Starting; Preparations For Jump Start - Chrysler 300c Owner's Manual

Hide thumbs Also See for 300c:
Table of Contents

Advertisement

20_LX_OM_ENA_GCC_t.book Page 208
208
IN CASE OF EMERGENCY

Road Tire Installation

1. Mount the road tire on the axle.
2. Install the remaining lug nuts with the cone
shaped end of the nut toward the wheel.
Lightly tighten the lug nuts.
WARNING!
To avoid the risk of forcing the vehicle off the
jack, do not tighten the wheel nuts fully until
the vehicle has been lowered. Failure to
follow this warning may result in serious
injury.
3. Lower the vehicle to the ground by turning
the jack handle counterclockwise.
4. Refer to "Wheel And Tire Torque Specifica-
tions" in "Technical Specifications" for
proper lug nut torque.
5. After 25 miles (40 km), check the lug nut
torque with a torque wrench to ensure that
all lug nuts are properly seated against the
wheel.

JUMP STARTING

If your vehicle has a discharged battery, it can
be jump started using a set of jumper cables
and a battery in another vehicle, or by using a
portable battery booster pack. Jump starting
can be dangerous if done improperly, so please
follow the procedures in this section carefully.
WARNING!
Do not attempt jump starting if the battery is
frozen. It could rupture or explode and cause
personal injury.
CAUTION!
Do not use a portable battery booster pack or
any other booster source with a system
voltage greater than 12 Volts or damage to
the battery, starter motor, alternator or
electrical system may occur.
NOTE:
When using a portable battery booster pack,
follow the manufacturer's operating instruc-
tions and precautions.

Preparations For Jump Start

The battery is stored under an access cover in
the trunk. Remote battery posts are located on
the right side of the engine compartment for
jump starting.
Jump Starting Locations
(+) — Remote Positive Post
(-) — Remote Negative Post
WARNING!
Take care to avoid the radiator cooling fan
whenever the hood is raised. It can start
anytime the ignition switch is ON. You can
be injured by moving fan blades.
(Continued)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents