Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Figure 584: Securing the TPM board
Ê Secure the TPM board with the TPM screw using the TPM bit insert.
I
Do not fasten the screw too firmly. Stop as soon as the head of the
screw lightly touches the TPM board.

14.3.1.4 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the air duct as described in section
on page 102.
Ê Close the side / top cover as described in section
on page 115 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
TX300 S7 / RX350 S7
"Mounting the side cover" on page 122
133.
Upgrade and Maintenance Manual
System board and components
"Installing the system air duct"
"Mounting the top cover"
132.
130.
"Connecting the server to
(tower
837