Front Lan Connector; Installing The Front Lan Connector; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Front panel and external connectors
13.2

Front LAN connector

13.2.1 Installing the front LAN connector

Upgrade and Repair Units (URU)
Average task duration: 10 minutes

13.2.1.1 Required tools

Preliminary and concluding steps: tool-less
●
Installing the front LAN connector:
●
– Slotted screw driver for breaking out the front LAN cover plate

13.2.1.2 Preliminary steps

Before installing the front LAN connector, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
778
141.
64.
72.
"Extending the server out of the rack" on page
Upgrade and Maintenance Manual
"Disabling BitLocker
"Locating the defective
"Shutting down the server" on
"Disconnecting the server
77.
TX300 S7 / RX350 S7
76.