13.2.3 Replacing the front LAN connector and board
Upgrade and Repair Units (URU)
Average task duration: 15 minutes
13.2.3.1 Required tools
Preliminary and concluding steps: tool-less
●
Replacing the front LAN connector: tool-less
●
13.2.3.2 Preliminary steps
Before replacing the front LAN connector, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page
71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 79
(rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
TX300 S7 / RX350 S7
141.
64.
72.
"Extending the server out of the rack" on page
"Removing the side cover" on page 88
79.
Upgrade and Maintenance Manual
Front panel and external connectors
"Locating the defective
"Shutting down the server" on
"Disconnecting the server
77.
"Removing the top cover"
"Disabling BitLocker
76.
(tower
793