Usb Flash Module (Ufm); Installing The Ufm Board; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

14.2

USB Flash Module (UFM)

This section provides information on how to install, remove or replace the USB
Flash Module (UFM).

14.2.1 Installing the UFM board

Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes

14.2.1.1 Required tools

Preliminary and concluding steps: tool-less
●
Installing the UFM: tool-less
●

14.2.1.2 Preliminary steps

Before installing the UFM board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
TX300 S7 / RX350 S7
141.
64.
72.
Upgrade and Maintenance Manual
System board and components
"Disabling BitLocker
142.
"Locating the defective
"Shutting down the server" on
"Disconnecting the server
"Disabling
819