Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.2.1.2

Preliminary steps

Before installing an expansion card, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê Shut down the server as described in section
page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 79 (rack server) or
server).
Ê Remove the air duct as described in section
on page 100.
414
141.
72.
"Extending the server out of the rack" on page
"Removing the side cover" on page 88
Upgrade and Maintenance Manual
"Disabling BitLocker
"Disabling
142.
"Shutting down the server" on
"Disconnecting the server
77.
"Removing the top cover"
"Removing the system air duct"
TX300 S7 / RX350 S7
76.
(tower