Removing The Front Panel Module; Removing The Defective Front Vga Connector; Installing The New Front Vga Connector; Reassembling The Front Panel Module - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Front panel and external connectors
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
Ê Remove the air duct as described in section
on page 100.
Ê Remove the system fan holder as described in section
system fan holder" on page

13.3.3.3 Removing the front panel module

Ê Remove the front panel module as described in section
panel module" on page

13.3.3.4 Removing the defective front VGA connector

Ê Remove the defective front VGA connector as described in section
"Removing the front VGA connector" on page

13.3.3.5 Installing the new front VGA connector

Ê Install the new front VGA connector as described in section
front VGA connector" on page

13.3.3.6 Reassembling the front panel module

Ê Mount the front panel module cover on the front panel frame as described in
section "Mounting the front panel module cover" on page

13.3.3.7 Reinstalling the front panel module

Ê Reinstall the front panel module as described in section
panel module" on page

13.3.3.8 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 102.
810
79.
389.
762.
796.
771.
390.
Upgrade and Maintenance Manual
"Removing the system air duct"
"Removing the
"Removing the front
806.
"Installing the
769.
"Installing the front
"Installing the system
"Installing the system air duct"
TX300 S7 / RX350 S7