Installing Accessible Drives; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

12.2

Installing accessible drives

Upgrade and Repair Units (URU)
Average task duration: 10 minutes

12.2.1 Required tools

Preliminary and concluding steps: tool-less
●
Installing accessible drives:
●
– Slotted screw driver (for bending in or out accessible drive mounting
brackets)

12.2.2 Preliminary steps

Before installing an accessible drive, perform the following steps:
Ê Shut down the server as described in section
page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 79 (rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
I
The front cover only needs to be removed in order to remove
accessible drive dummy covers.
TX300 S7 / RX350 S7
72.
"Extending the server out of the rack" on page
"Removing the side cover" on page 88
79.
Upgrade and Maintenance Manual
Accessible drives
"Shutting down the server" on
"Disconnecting the server
77.
"Removing the top cover"
76.
(tower
655