Removing The 8X 2.5-Inch Hdd Extension Box; Installing The 8X 2.5-Inch Hdd Extension Box; Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

7.4.10.3 Removing the 8x 2.5-inch HDD extension box

Ê Unlock and pull the 8x 2.5-inch HDD extension box out of its installation bays
as described in section
page 359.

7.4.10.4 Installing the 8x 2.5-inch HDD extension box

Ê Install the new 8x 2.5-inch HDD extension box as described in section
"Installing the 8x 2.5-inch HDD extension box" on page

7.4.10.5 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 102.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page
Ê Reinstall all hard disk drives into their original slots in the HDD extension box
as described in section
Ê Close the side / top cover as described in section
on page 115 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
TX300 S7 / RX350 S7
"Removing the 8x 2.5-inch HDD extension box" on
390.
112.
"Installing 3.5-inch HDD modules" on page
"Mounting the side cover" on page 122
133.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Installing the system
"Installing the system air duct"
"Mounting the top cover"
132.
130.
"Connecting the server to
349.
272.
(tower
367