Removing Accessible Drive Dummy Covers; Removing Accessible Drive Filler Covers - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Accessible drives
Ê Remove the air duct as described in section
on page 100.
Ê Remove the system fan holder as described in section
system fan holder" on page

12.2.3 Removing accessible drive dummy covers

12.2.3.1 Removing accessible drive filler covers

Figure 450: Removing an accessible drive filler cover
Ê Hold the accessible drive filler cover by its two handle recesses and pull it
out of the desired installation bay.
V
CAUTION!
Always replace filler covers into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
656
389.
Upgrade and Maintenance Manual
"Removing the system air duct"
"Removing the
TX300 S7 / RX350 S7