Preparing The Modular Lan Controller - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê Open the side / top cover as described in section
on page 79 (rack server) or
server).
Ê Remove the air duct as described in section
on page 100.
9.3.1.3

Preparing the Modular LAN controller

Mounting the slot bracket
Figure 271: Mounting the PCI slot bracket (A)
Ê Place the controller on the mounting tabs on the slot bracket.
Ê Carefully shift the slot bracket towards the controller until the plug shells
engage with the cut-outs in the slot bracket connector panel.
TX300 S7 / RX350 S7
"Removing the side cover" on page 88
Upgrade and Maintenance Manual
Expansion cards and backup units
"Removing the top cover"
"Removing the system air duct"
(tower
435