Removing A Processor - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Processors
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 79 (rack server) or
server).
Ê Remove the air duct as described in section
on page 100.
Ê Remove the desired processor heat sink as described in section
processor heat sinks" on page

11.3.3 Removing a processor

I
This description applies to the following procedures:
– Removing CPU 2 from a dual-processor configuration
– Removing CPUs from a defective system board (see section
"Swapping processors" on page
Ê Remove the desired processor heat sink as described in section
processor heat sinks" on page
618
72.
"Extending the server out of the rack" on page
"Removing the side cover" on page 88
646.
646.
Upgrade and Maintenance Manual
"Disconnecting the server
77.
"Removing the top cover"
"Removing the system air duct"
867)
TX300 S7 / RX350 S7
76.
(tower
"Removing
"Removing