Removing The 4X 3.5-Inch Hdd Extension Box; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
7.4.6

Removing the 4x 3.5-inch HDD extension box

Upgrade and Repair Units (URU)
Average task duration: 10 minutes
7.4.6.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing the HDD extension box: tool-less
●
7.4.6.2

Preliminary steps

Before removing the HDD extension box, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 79 (rack server) or
server).
Ê Remove all HDD modules from the HDD extension box as described in
section "Removing 3.5-inch HDD modules" on page
340
165.
141.
72.
"Extending the server out of the rack" on page
"Removing the side cover" on page 88
Upgrade and Maintenance Manual
"Disabling BitLocker
"Shutting down the server" on
"Disconnecting the server
77.
"Removing the top cover"
277.
TX300 S7 / RX350 S7
"Enabling
76.
(tower