Fans
8.3.3
Replacing rear fan modules
Customer Replaceable Units (CRU)
Average task duration: 5 minutes
8.3.3.1
Required tools
Preliminary and concluding steps: tool-less
●
Replacing the fan module: tool-less
●
8.3.3.2
Preliminary steps
Before replacing a rear fan module, perform the following steps:
Ê Locate the desired server as described in section
server" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 79
(rack server) or
server).
Ê Locate the defective fan using the onboard Local Diagnostic LEDs as
described in section
8.3.3.3
Removing rear fan modules
Ê Remove the defective rear fan module(s) as described in section
rear fan modules" on page
8.3.3.4
Installing rear fan modules
Ê Replace the defective rear fan module(s) as described in section
rear fan modules" on page
400
64.
"Extending the server out of the rack" on page
"Removing the side cover" on page 88
"Onboard indicators and controls" on page
396.
392.
Upgrade and Maintenance Manual
"Locating the defective
77.
"Removing the top cover"
TX300 S7 / RX350 S7
76.
(tower
951.
"Removing
"Installing