Hard disk drives / solid state drives
7.2.6.4
Installing a 2.5-inch HDD / SSD dummy module
V
CAUTION!
If the removed HDD / SSD module is not replaced immediately, always
replace a dummy module into the unused HDD / SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 108: Installing a 2.5-inch HDD / SSD dummy module
Ê Slide the HDD dummy module into the drive bay until it locks in place.
7.2.6.5
Concluding steps
Perform the following procedures to complete the task:
Ê When working on a tower server, close the HDD bay cover as described in
section
"Installing accessible drive and HDD bay covers" on page
222
Upgrade and Maintenance Manual
119.
TX300 S7 / RX350 S7