Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Converting a tower server to a rack server
15.2

Preliminary steps

Before converting the server model, perform the following steps:
Ê Shut down the server as described in section
page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê Remove all external cables.
Ê Open the side cover as described in section
page 85.
Ê Pull out the ID card and open the front cover as described in section
"Removing the ID card" on page
Ê When working on a tower server, open the HDD bay cover as described in
section "Removing accessible drive and HDD bay covers" on page
Ê Remove the front cover as described in section
on page 94.
I
The front cover is no longer required.
Ê If applicable, remove all HDDs or HDD dummy modules from an installed
HDD extension box as described in the following sections:
– "Removing a 2.5-inch HDD / SSD module" on page 220
– "Removing a 2.5-inch HDD / SSD dummy module" on page 215
– "Removing a 3.5-inch HDD module" on page 279
– "Removing a 3.5-inch HDD dummy module" on page 273
Ê Remove all accessible drives, extension boxes and filler covers as
described in the following sections:
– "Removing accessible drives" on page 675
– "Removing accessible drive filler covers" on page 656
– "HDD extension boxes" on page 309
Ê If applicable, remove the anti-tilt bracket as described in section
the anti-tilt bracket" on page
884
72.
90.
129.
Upgrade and Maintenance Manual
"Shutting down the server" on
"Disconnecting the server
"Unlocking the server" on
"Removing the front cover"
TX300 S7 / RX350 S7
91.
"Removing