Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 221

Ê Pinch the green locking clips (1) and fully open the locking lever (2).
I
Thereby, the HDD / SSD module is pushed out of its drive bay by
about 1 cm and disconnected from the SAS / SATA backplane.
Ê Wait about 30 seconds to allow the hard disk drive to spin down.
I
This is not necessary when removing a solid state drive.
Figure 107: Removing a 2.5-inch HDD / SSD module
Ê Pull the HDD / SSD module completely out of its bay.
TX300 S7 / RX350 S7
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
221