Installing The Heat Sink - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Processors
When reusing a heat sink
Ê Ensure that all residual thermal paste has been thoroughly cleaned off the
copper surface of the heat sink.
Ê Apply thermal paste to the processor surface as described in section
"Applying thermal paste" on page

11.5.3.2 Installing the heat sink

H
Figure 441: Installing the heat sink (A)
Ê Align the heat sink with the uncovered copper heat pipes (H, see above)
facing towards the server top.
644
649.
Upgrade and Maintenance Manual
TX300 S7 / RX350 S7