Removing A Memory Module - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê Open the side / top cover as described in section
on page 79 (rack server) or
server).
Ê Remove the air duct as described in section
on page 100.

10.3.3 Removing a memory module

Ê Identify the desired memory slot according to the mounting order described
in section "Memory sequence" on page
V
CAUTION!
Ensure to maintain an operational configuration when removing
memory modules. For additional information, please refer to section
"Basic information" on page
Figure 407: Removing memory modules (A)
Ê Eject the desired memory module by pressing out the securing clips at each
end of the memory module connector.
I
For lack of space, it is necessary to remove the rear fan modules
(fans 5 and 6) in order to install or remove memory modules in
channels E and F or channels G and H. For further information,
please refer to section
TX300 S7 / RX350 S7
"Removing the side cover" on page 88
584.
"Removing a rear fan module" on page
Upgrade and Maintenance Manual
"Removing the top cover"
"Removing the system air duct"
584.
Main memory
(tower
397.
597