Removing The 4X 3.5-Inch Hdd Extension Box; Removing The Slimline Odd From The Defective Hdd Extension Box; Installing The Slimline Odd And Lsd Module Into The New Hdd Extension Box; Installing The 4X 3.5-Inch Hdd Extension Box - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
7.4.7.3

Removing the 4x 3.5-inch HDD extension box

Ê Unlock and pull the 4x 3.5-inch HDD extension box out of its installation bays
as described in section
page 340.
7.4.7.4 Removing the slimline ODD from the defective HDD extension
box
Ê If applicable, remove the slimline ODD from the defective 4x 3.5-inch HDD
extension box as described in section
extension box" on page
7.4.7.5 Installing the slimline ODD and LSD module into the new HDD
extension box
Ê If applicable, reinstall the slimline ODD into the new 4x 3.5-inch HDD
extension box as described in section
HDD extension box" on page
7.4.7.6

Installing the 4x 3.5-inch HDD extension box

Ê Install the new 4x 3.5-inch HDD extension box as described in section
"Installing the 4x 3.5-inch HDD extension box" on page
7.4.7.7

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 102.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page
Ê Reinstall all hard disk drives into their original slots in the HDD extension box
as described in section
Ê Close the side / top cover as described in section
on page 115 (rack server) or
server).
348
"Removing the 4x 3.5-inch HDD extension box" on
750.
740.
390.
112.
"Installing 3.5-inch HDD modules" on page
"Mounting the side cover" on page 122
Upgrade and Maintenance Manual
"Removing the slimline ODD from the
"Installing the slimline ODD into the
"Installing the system
"Installing the system air duct"
"Mounting the top cover"
330.
272.
(tower
TX300 S7 / RX350 S7