Cabling The Sas Backplanes; Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Figure 184: Mounting the 3.5-inch HDD bay top cover (C)
Ê Secure the HDD bay top cover to the chassis with five M3 x 4.5 mm screws
(see blue arrows).
Ê Secure the intrusion switch holder on the HDD bay top cover with one
M3 x 4.5 mm screw (see orange arrow).

7.3.10.8 Cabling the SAS backplanes

Ê Connect SAS and power cables to the 2.5-inch SAS backplanes as
described in section

7.3.10.9 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 102.
TX300 S7 / RX350 S7
"8x 3.5-inch HDD SAS backplane cabling" on page
390.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Installing the system
"Installing the system air duct"
261.
307