Removing Pci Slot Brackets - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.1.4

Removing PCI slot brackets

Figure 288: Removing the PCI slot bracket (A)
I
Ensure that the GPGPU card power cables have been connected to the
power backplane as described in section
power cables to the power backplane" on page
Ê Press out on the locking latch to disengage the PCI slot bracket locking bar
(1, see close-up).
Ê Fold up (2) and remove (3) the PCI slot bracket locking bar.
I
The PCI slot mounting bar is no longer required if installing one or two
GPGPU cards. Set aside and save the mounting bar for future use.
Ê Disconnect the system power cable (T26139-Y3758-V9) from the system
board (4).
460 Upgrade and Maintenance Manual
"Connecting GPGPU card
458.
TX300 S7 / RX350 S7