12.6
Slimline ODD and LSD in 2x 3.5-inch HDD
extension box
12.6.1 Installing the slimline ODD or LSD
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
12.6.1.1 Required tools
Preliminary and concluding steps: tool-less
●
Installing a slimline ODD or LSD:
●
– Slotted screw driver (for bending in or out accessible drive mounting
brackets)
12.6.1.2 Preliminary steps
Before installing a slimline ODD or LSD, perform the following steps:
Ê Shut down the server as described in section
page
71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 79
(rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
TX300 S7 / RX350 S7
72.
"Extending the server out of the rack" on page
"Removing the side cover" on page 88
79.
Upgrade and Maintenance Manual
Accessible drives
"Shutting down the server" on
"Disconnecting the server
77.
"Removing the top cover"
76.
(tower
715