Installing A New Bbu Module; Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

9.7.6.5

Installing a new BBU module

Ê Install the new BBU into the BBU holder as described in section
the BBU" on page
Ê Install the BBU holder into the chassis as described in section
BBU holder into the chassis" on page
Ê Connect the BBU to the controller.
9.7.6.6

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 102.
Ê Close the side / top cover as described in section
on page 115 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê If applicable, update the firmware of the RAID controller that has been
connected to the BBU as described in section
firmware" on page
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
TX300 S7 / RX350 S7
543.
390.
"Mounting the side cover" on page 122
133.
153.
Upgrade and Maintenance Manual
Expansion cards and backup units
545.
"Installing the system
"Installing the system air duct"
"Mounting the top cover"
132.
130.
"Connecting the server to
"Updating RAID controller
159.
"Preparing
"Installing the
(tower
"Enabling SVOM
569