Replacing The Modular Lan Controller; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.3.3

Replacing the Modular LAN controller

Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
9.3.3.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing the Modular LAN controller: tool-less
●
Mounting slot brackets:
●
– Phillips PH2 / (+) No. 2 screw driver
9.3.3.2

Preliminary steps

Before replacing an expansion card, perform the following steps:
Ê Ensure to note down your current network settings in the operating system.
For further information, please refer to section
recovery" on page
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
452
429.
141.
Upgrade and Maintenance Manual
"Note on network settings
"Disabling BitLocker
"Disabling
142.
TX300 S7 / RX350 S7