Removing The Front Panel Module; Preparing The Front Panel Module - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê Open the side / top cover as described in section
on page 79 (rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
Ê Remove the air duct as described in section
on page 100.
Ê Remove the system fan holder as described in section
system fan holder" on page

13.2.1.3 Removing the front panel module

Ê Disconnect the front panel cables from the system board as described in
section "Removing front panel cables from the system board" on page
Ê Remove the front panel module from the chassis as described in section
"Removing the front panel module" on page

13.2.1.4 Preparing the front panel module

Ê Remove the front panel module cover from the front panel frame as
described in section
Figure 546: Breaking out the front LAN cover plate
TX300 S7 / RX350 S7
"Removing the side cover" on page 88
79.
389.
"Removing the front panel module cover" on page
Upgrade and Maintenance Manual
Front panel and external connectors
"Removing the top cover"
"Removing the system air duct"
765.
(tower
"Removing the
762.
768.
779