Removing The Lsd Module From The Multibay Box - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Accessible drives
Ê Fit the slimline ODD dummy insert into the slimline ODD installation frame.
Ê Ensure that the four pins on the frame (see arrows) engage with the side
holes on the dummy insert.
Ê Insert the slimline ODD dummy module into the Multibay box and push back
until the locking tab engages as shown in

12.5.2.5 Removing the LSD module from the Multibay box

Figure 496: Removing the 3.5-inch installation frame from the Multibay box (A)
Ê Remove two screws on either side of the Multibay box to disengage the 3.5-
inch installation bay.
708 Upgrade and Maintenance Manual
figure 478 on page
TX300 S7 / RX350 S7
690.