Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 676

Accessible drives
Ê Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section
configuring the backup software solution" on page
Ê Shut down the server as described in section
page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 79 (rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
I
The front cover only needs to be removed in order to install
accessible drive dummy covers (see section
drive dummy covers" on page
after being removed, leave the front cover installed.
Ê Remove the air duct as described in section
on page 100.
Ê Remove the system fan holder as described in section
system fan holder" on page
676
72.
"Extending the server out of the rack" on page
"Removing the side cover" on page 88
79.
389.
Upgrade and Maintenance Manual
"Verifying and
144.
"Shutting down the server" on
"Disconnecting the server
77.
"Removing the top cover"
"Installing accessible
681). If the accessible drive is replaced
"Removing the system air duct"
76.
(tower
"Removing the
TX300 S7 / RX350 S7