Extending / Removing The Server From The Rack; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

4.4 Extending / removing the server from the
rack
I
In most cases maintenance tasks can be performed while the server is
extended from the rack. However, depending on accessibility or security
guidelines, it may make sense to completely remove the server from the
rack cabinet for maintenance purposes.
V
CAUTION!
Use the anti-tilt plate to prevent the rack from tipping when installing
●
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
Be careful not to pinch fingers or clothes when sliding out the server
●
or pushing it back. Failure to do so may cause injury.
For further safety information, please refer to chapter
●
information" on page
4.4.1

Preliminary steps

Ê Shut down and power off the server as described in section
the server" on page
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê Remove all remaining external cables from the rear connector panel and
expansion cards. For further information, refer to section
indicators" on page
TX300 S7 / RX350 S7
51.
71.
72.
948.
Upgrade and Maintenance Manual
Basic hardware procedures
"Important
"Shutting down
"Disconnecting the server
"Connectors and
75