Removing The Onboard Sas Enabling Key; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page

14.4.2 Removing the onboard SAS enabling key

Upgrade and Repair Units (URU)
Average task duration: 5 minutes

14.4.2.1 Required tools

Preliminary and concluding steps: tool-less
●
Removing the onboard SAS enabling key: tool-less
●

14.4.2.2 Preliminary steps

Before removing the onboard SAS enabling key, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
TX300 S7 / RX350 S7
133.
165.
141.
72.
"Extending the server out of the rack" on page
Upgrade and Maintenance Manual
System board and components
"Connecting the server to
"Disabling BitLocker
"Shutting down the server" on
"Disconnecting the server
77.
"Enabling
76.
851