Ê Close the side / top cover as described in section
on page 115
(rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section
"Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
12.5.2 Removing a slimline ODD or LSD
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
12.5.2.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing a slimline ODD or LSD:
●
– Phillips PH2 / (+) No. 2 screw driver
12.5.2.2 Preliminary steps
Before removing a slimline ODD or LSD, perform the following steps:
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page
144.
Ê Shut down the server as described in section
page
71.
TX300 S7 / RX350 S7
"Mounting the side cover" on page 122
133.
"Removing backup and optical disk media" on
Upgrade and Maintenance Manual
Accessible drives
"Mounting the top cover"
132.
130.
"Connecting the server to
"Shutting down the server" on
(tower
701