Connecting Cables To The Expansion Card - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
Figure 265: Securing the expansion card
Ê Secure InfiniBand cards with one M3 x 4.5 mm screw each.
I
In case of all other standard expansion cards, fixation with the locking
bar is sufficient.
Ê Insert (1) and close the PCI slot bracket locking bar (2) until the latch locks
in place (see close-up).
Ê If applicable, install SFP+ transceiver modules into the new expansion card,
as described in section
9.2.1.6

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
overviews" on page
422
"Installing SFP+ transceiver modules" on page
911.
Upgrade and Maintenance Manual
575.
"Cabling
TX300 S7 / RX350 S7