Installing The 4X 3.5-Inch Hdd Extension Box; Required Tools - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page
Ê Reinstall all hard disk drives into their original slots in the HDD extension box
as described in section
Ê Close the side / top cover as described in section
on page 115 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
7.4.5

Installing the 4x 3.5-inch HDD extension box

Upgrade and Repair Units (URU)
Average task duration: 10 minutes
7.4.5.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing the HDD extension box:
●
– Slotted screw driver (for bending in or out accessible drive mounting
brackets)
330
112.
"Installing 3.5-inch HDD modules" on page
"Mounting the side cover" on page 122
133.
Upgrade and Maintenance Manual
"Mounting the top cover"
132.
130.
"Connecting the server to
TX300 S7 / RX350 S7
272.
(tower