Fujitsu PRIMERGY TX300 S4 Start Manual

n SATA Hard Disk Unit
The SATA hard disk that is installed in the SATA model is designed to be used about eight hours per day for five years with small scale and
comparatively low access frequency.
Refrain from using for mission-critical tasks in which continuous 24/7/365 operation is necessary, or database in which the access is frequently
repeated, and high reliability is required.
To prevent the loss of important data, regular data backup is recommended.
n PRIMERGY TX300 S4 Manuals
Manuals for this server are stored in the PRIMERGY Startup Disc. Insert the PRIMERGY Startup Disc and click [PRIMERGY Manuals] on the
[PRIMERGY Startup Disc] screen to refer to the manuals.
The manuals can be read using Acrobat® Reader® or Adobe® Reader®. When using Acrobat® Reader®, use version 5.0 or later.
1
Checking the items
supplied
Check the contents in the package using
the "Contents List".
If any items are missing, contact an office listed
in the "Contact Information".
3
Installing internal options
If internal options have been purchased separately, install them before installing an operating system.
If you use Custom Made Service, installing internal
options is not required. Just check "
before installing an OS".
n Points to note before installing an OS
When using the optional devices listed below, note the fol-
lowing instruction before installing an OS.
- Internal Data Cartridge Drive Unit
Insert a data cartridge after installing an OS.
If a data cartridge is inserted, remove it.
- Internal HDD Unit Bay Conversion kit
When an array is configured with internal hard disk units
installed in Internal HDD Unit Bay Conversion kit, delete
the array configuration. After the OS is installed, reset the
array configuration.
- Optional external devices
- When an array is configured with hard disk units in-
stalled in PRIMERGY SX35, delete the array configura-
tion. After installing an OS, configure the array again.
- When connecting an external storage system such as
ETERNUS, do not turn on the power until the OS instal-
lation completes.
TX300 S4
n Points to note
1
2
Reading and understanding
"Safety Precautions"
Before using this server, be sure to read and un-
derstand the attached "Safety Precautions".
n Available Internal options and installation
locations
When installing internal options, make sure to refer to "User's
Guide Chapter 6 Installing Internal Options" and manuals sup-
plied with the optional devices.
�������������� ���
������
���������������
After installing internal options, check that the order and
location of installation are correct and cables are correctly
connected.
B7FH-5711-01EN-00
����������������������
�������
������������������������