Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 473

– The number of ECC Errors (4) has not greatly increased (beyond 100)
during a number of hours.
I
In order to reset the ECC error counter, enter the following
command: nvidia-smi [-p/-v] -g <GPUID>
Ê If one or more of the above conditions is not fulfilled, although sufficient
power supply has been assured as described in section
operation" on page
TX300 S7 / RX350 S7
474, replace the GPGPU card.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Checking GPGPU
473