Removing Accessible Drives; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page
12.3

Removing accessible drives

Upgrade and Repair Units (URU)
Average task duration: 10 minutes

12.3.1 Required tools

Preliminary and concluding steps: tool-less
●
Removing accessible drives: tool-less
●

12.3.2 Preliminary steps

Before removing an accessible drive, perform the following steps:
Ê Locate the desired server as described in section
server" on page
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page 144.
TX300 S7 / RX350 S7
133.
64.
"Removing backup and optical disk media" on
Upgrade and Maintenance Manual
Accessible drives
132.
130.
"Connecting the server to
"Locating the defective
155.
675