Removing The 4X 3.5-Inch Hdd Extension Box - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
Ê Remove the air duct as described in section
on page 100.
Ê Remove the system fan holder as described in section
system fan holder" on page
7.4.6.3

Removing the 4x 3.5-inch HDD extension box

Figure 212: Opening the accessible drive locking bar
Ê Remove all cables from the 4x 3.5-inch HDD extension box backplane.
Ê If applicable, remove all cables from the slimline ODD.
Ê Press out on the locking latch to disengage the accessible drive locking bar
(1).
TX300 S7 / RX350 S7
79.
389.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Removing the system air duct"
"Removing the
341