Replacing A Gpgpu / Coprocessor Card; Required Tools; Preliminary Steps; Removing The Gpgpu Air Duct - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

9.5.2

Replacing a GPGPU / coprocessor card

Field Replaceable Units (FRU)
Average hardware task duration: 10 minutes
Average software task duration: 5 minutes
9.5.2.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing a GPGPU card / coprocessor card:
●
– GPGPU card Intel Xeon Phi:
– Phillips PH1 / (+) No. 1 screw driver
– Coprocessor card Nvidia TESLA K20 / K20X:
– Phillips PH2 / (+) No. 2 screw driver
9.5.2.2

Preliminary steps

Ê Proceed as described in chapter
9.5.2.3

Removing the GPGPU air duct

Ê Proceed as described in section
page 509 in reverse order.
9.5.2.4

Removing a GPGPU / coprocessor card

Ê Disconnect all cables from the GPGPU / coprocessor card(s).
Ê Proceed as described in section
on page 498 in reverse order.
9.5.2.5

Installing a GPGPU / coprocessor card

Ê Proceed as described in section
on page 498.
TX300 S7 / RX350 S7
"Before you start" on page 39
"Installing the GPGPU air duct" on
"Installing a GPGPU or coprocessor card"
"Installing a GPGPU or coprocessor card"
Upgrade and Maintenance Manual
Expansion cards and backup units
527