Nortel DMS-100 Series Maintenance Manual page 319

4 Remove the line card to be replaced by using the following steps:
a. Slide a card shroud over the card to be removed and an adjacent card. (If
there is not an adjacent card on either side, do not use the card shroud.)
b. Grasp the edge of the card with a line card extractor at a point midway
between the top and bottom edges. Hold the extractor in your right hand.
c. Squeeze the handles of the extractor together to grasp the card tightly.
d. Hold the front cover of the line drawer to steady it with your left hand.
e. Pull the extractor away from the drawer to unplug the card from its socket
on the drawer backplane.
f. Continue pulling the card with the extractor until the card is clear of the
shroud.
RLCM-EDC card replacement procedures 6-131
Replacing a line card
in an LCM
Extractor
DMS-100 Family Maintenance Manual ABSK007
(continued)