6-60 RLCM-EDC card replacement procedures
NT2X90
in RMM
(continued)
At the RMM shelf
6
7
8
297-8381-550 Standard 02.02 April 1999
CAUTION
Static discharge may cause damage to circuit packs
Connect a wrist strap to the frame of the RMM before
you remove or insert any cards. This protects the
RMM against service degradation that static electricity
causes.
Put on a wrist strap.
To replace the NT2X90 card use the procedure Replacing a card. When you
complete the procedure, return to this point.
Use the information that follows to determine the next step in this procedure.
If you enter this procedure
from an alarm clearing procedure
from other
Do
step 18
step 9