Nortel DMS-100 Series Maintenance Manual page 30

1-18 Maintenance overview
BSY command Option smaller memory (SMEM) is used with the option
ALL
allows operating company personnel to take advantage of the InSv loading
feature of the RLCM-EDC when loading multiple LCMs. A load operation
on multiple existing LCMs require the units being loaded to be in a
state. The BSY command used with option
ManB
units, including RLCM-EDC units, into a
busy the RLCM-EDC units for loading. When option
option
placed in the
command shown in the following example of a MAP display and load the
posted set, which can include both existing LCMs and RLCM-EDCs.
>BSY UNIT 0 ALL SMEM
Example of MAP response
This operation will be performed on 2 LCMs.
Please confirm ("YES","Y","NO","N"):.
>Y
LCM HOST 01 0 Unit 0 Calls On Unit May Be Affected
Please confirm ("YES", "Y", "NO", or "N"):
>Y
LCM REM1 01 0 Unit 0 Request not submitted:Not an SMEM LCM
LCM HOST 02 0 Unit 0 Bsy passed
Summary:
1 Passed.
1 not submitted
297-8381-550 Standard 02.02 April 1999
The option can only be used if both units are in the same state such
PM
as, InSv, ISTb or ManB. If the LCM being loaded has two different
states such as, one unit InSv and one unit OOS, the operating company
personnel must use the
If one unit of the RLCM-EDC is performing a
cannot perform any loading functions.
prior to parallel loading a set of posted LCMs. This command option
state. Using the existing command
, only non-RLCM-EDC units (64K/256K) of the posted set are
ALL
state. Operating company personnel can issue the
ManB
The BSY command will remove a unit or whole PM from service and
should be executed during periods of low traffic.
option and load each unit separately.
UNIT
ALL
BSY ALL
ManB
ATTENTION
load, the other unit
MATE
ManB
sets the LCM units in the
places all posted LCM
state. It is not necessary to
is used with
SMEM