References In This Document; What Precautionary Messages Mean - Nortel DMS-100 Series Maintenance Manual

viii About this document
organized, check the release information in Product Documentation
Directory, 297-8991-001.

References in this document

The following documents are referred to in this document:

What precautionary messages mean

The types of precautionary messages used in NT documents include
attention boxes and danger, warning, and caution messages.
An attention box identifies information that is necessary for the proper
performance of a procedure or task or the correct interpretation of
information or data. Danger, warning, and caution messages indicate
possible risks.
Examples of the precautionary messages follow.
ATTENTION Information needed to perform a task
DANGER
297-8381-550 Standard 02.02 April 1999
PAlarm Clearing Procedures
PCard Replacement Procedures
POperational Measurements Reference Manual
PInput/Output System Reference Manual, 297-1001-129
PTranslations Guide
PProvisioning Guide, PLN–8991–104
If the unused DS-3 ports are not deprovisioned before a DS-1/VT
Mapper is installed, the DS-1 traffic will not be carried through the
DS-1/VT Mapper, even though the DS-1/VT Mapper is properly
provisioned.
Possibility of personal injury
DANGER
Risk of electrocution
Do not open the front panel of the inverter unless fuses
F1, F2, and F3 have been removed. The inverter contains
high-voltage lines. Until the fuses are removed, the
high-voltage lines are active, and you risk being
electrocuted.
ATTENTION