Nortel DMS-100 Series Maintenance Manual page 299

Replacing an NT6X73 card in HIE
At your current location
1 Continue with this procedure if:
a step in a a maintenance procedure directs you to this card replacement
procedure
you use this procedure to verify or accept cards
your maintenance support group directs you to this procedure.
2
Obtain a replacement card. Make sure the replacement card has the same
PEC and PEC suffix of the card to be removed.
3 If another maintenance procedure directed you to this procedure, go to step 7.
If another maintenance procedure did not direct you to this procedure, continue
with step 4.
At the MAP terminal
4 To access the peripheral module (PM) level and to post the line concentrating
module (LCM), type:
>MAPCI;MTC;PM;POST LCM site cabinet lcm
and press the Enter key.
where
site is the site name of the RLCM-EDC (alphanumeric)
cabinet is the number of the RLCC-EDC cabinet
lcm is the number of the LCM
5
Use the following table to determine the LCM unit associated with the defective
NT6X73:
LCM unit
0
1
6
CAUTION
Loss of service
This procedure contains directions to busy one or
more PMs in a frame. Busying a PM affects
subscriber service. Replace power converters during
periods of low traffic
RLCM-EDC card replacement procedures 6-111
LCC card
LCC0
LCC1
DMS-100 Family Maintenance Manual ABSK007
NT6X73
in HIE
(continued)
LCC slot
17
18