Rear Combination Light Assembly - Subaru Legacy 2005 Service Manual

20.Rear Combination Light As-
sembly
A: REMOVAL
1. SEDAN MODEL
1) Disconnect the ground cable from battery.
2) Remove the trunk room side trim. <Ref. to EI-71,
REMOVAL, Trunk Room Trim.>
3) Remove the four nuts, and then detach the rear
combination light after disconnecting the connec-
tor.
2. WAGON MODEL
1) Disconnect the ground cable from battery.
2) Remove the clips.
3) While pressing the portion (A), insert your finger
or flat-tip screwdriver wrapped with tape into the
clearance (B) to remove pawls in the order of (C),
(D), (E), and remove the rear combination cover.
(A)
(B)

Rear Combination Light Assembly

LI-00294
LI-00295
(E)
(C)
(D)
LI-00284
LI-25
4) Remove the two bolts, and then detach the rear
combination light by pulling it to the rear side of ve-
hicle.
5) Remove the rear combination light after turning
the socket of tail/stop light bulb and rear turn signal
light bulb to remove the bulbs.
B: INSTALLATION
Install in the reverse order of removal.
LIGHTING SYSTEM
LI-00296