Subaru Legacy 2005 Service Manual page 3774

WIPER AND WASHER SYSTEMS
10.Rear Wiper Motor
A: REMOVAL
1. WAGON MODEL
1) Disconnect the ground cable from battery.
2) Remove the rear wiper arm. <Ref. to WW-21,
WAGON MODEL, REMOVAL, Rear Wiper Arm.>
3) Remove the rear gate lower trim. <Ref. to EI-69,
REMOVAL, Rear Gate Trim.>
4) Disconnect the harness connector of wiper mo-
tor assembly.
5) Remove the bolts to remove wiper motor assem-
bly (A).
B: INSTALLATION
1. WAGON MODEL
1) Install in the reverse order of removal.
2) Be sure that the pivot cap with the arrow mark
facing up, as shown in the figure.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion".
<Ref. to WW-4, REAR WIPER (WAGON MOD-
EL), COMPONENT, General Description.>
Rear Wiper Motor
(A)
WW-00183
WW-00185
WW-22
C: INSPECTION
1) Connect the battery to wiper motor connector
and confirm that wiper motor operates.
2) Connect the battery to terminals of connector,
and remove the terminal connection with wiper mo-
tor rotated, and stop the wiper motor through oper-
ation.
3) Connect the battery and confirm that the wiper
motor stops at automatic stop position after the
wiper motor operates at low speed again.
2 1
4 3
2 1
4 3
WW-00186
2 1
4 3
WW-00187
WW-00032