Table of Contents
Advertisement
EXTERIOR BODY PANELS
3. Front Fender
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the side sill spoilers. <Ref. to EI-41, RE-
MOVAL, Side Sill Spoiler.>
3) Remove the front grille. <Ref. to EI-24, REMOV-
AL, Front Grille.>
4) Remove the front bumper face. <Ref. to EI-30,
REMOVAL, Front Bumper.>
5) Remove the headlight assembly. <Ref. to LI-14,
REMOVAL, Headlight Assembly.>
6) Remove the mud guard. <Ref. to EI-29, RE-
MOVAL, Mud Guard.>
7) Remove the cowl side panel.
8) Remove the bolt, and remove the front fender
panel.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Install with attention to make uniform clearance
between front fender panel and front hood panel.
For the dimension of clearance, refer to "SPECIFI-
CATIONS" in "General Description". <Ref. to EB-2,
SPECIFICATION, General Description.>
Tightening torque:
⋅
7.4 N
m (0.75 kgf-m, 5.5 ft-lb)
Front Fender
EB-00147
EB-00146
EB-16
Advertisement
Chapters
Table of Contents
