Subaru Legacy 2005 Service Manual page 3985

2. REPAIR INSTRUCTIONS FOR COLORED PP BUMPER
NOTE:
All PP bumpers are provided with a grained surface, and if the surface is damaged, it cannot normally be re-
stored to its original condition. Damages limited to the shallow scratches that cause only a change in the lus-
ter of the base material or coating, can be almost fully restored. Before repairing a damaged area, explain this
point to the customer and obtain an understanding about the matter. Repair methods are outlined below,
based on a classification of the extent of damage.
1) Minor damage of only a change in luster of the bumper caused by a light touch
Almost restorable.
Pro-
cess Process name
No.
1 Cleaning
2 Sanding
3 Finish
2) Deep damage caused by scratching with fences
A dent cannot be repaired but a whitened or swelled part can be removed.
Pro-
cess Process name
No.
1 Cleaning
Removal of dam-
2
aged area
3 Sanding
4 Finish
Front Bumper
Clean the area to be repaired using water.
Grind the repairing area with #500 sand paper in a "feathering" motion.
Resin section
Repeatedly apply wax to the affected area
using a soft cloth (such as flannel). Recom-
mended wax: NITTO KASEI Soft 99 TIRE WAX
BLACK, or equivalent.
Polish the waxed area with a clean cloth after 5
to 10 minutes.
Clean damaged area with water.
Cut off protruding area, if any, due to collision, using a putty knife.
Grind the affected area with #100 to #500 sand paper.
Resin section
Same as Process No. 3 in the 1) section.
Job contents
Perform either the same process as for the
resin section or process No. 18 and subse-
quent in the 3) section, depending on the
degree and nature of damage.
Job contents
Perform Process No. 12 and subsequent oper-
ations in the 3) section.
EI-33
EXTERIOR/INTERIOR TRIM
Coated section
Coated section