Subaru Legacy 2005 Service Manual page 4050

EXTERIOR BODY PANELS
2. FRONT DOOR ASSEMBLY
1) Disconnect the ground cable from battery.
2) Remove the front pillar lower trim. <Ref. to EI-60,
REMOVAL, Lower Inner Trim.>
3) Remove the instrument panel lower cover or
glove box lower cover. <Ref. to EI-50, REMOVAL,
Instrument Panel Lower Cover.> or <Ref. to EI-51,
REMOVAL, Glove Box.>
4) Disconnect the connector of door harness from
body harness.
5) Put a wooden block on jack and place jack under
the front door. Support the door with a jack to pro-
tect it from damage.
6) Remove the bolt from the door checker.
Front Door
7) Remove the door-side bolts for upper and lower
hinges to remove front door panel.
8) Remove the door hinge from vehicle.
B: INSTALLATION
1. FRONT DOOR PANEL
Install in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
EB-00151
tion". <Ref. to EB-8, FRONT DOOR PANEL,
COMPONENT, General Description.>
2. FRONT DOOR ASSEMBLY
1) Put a wooden block on jack and place the front
door on that.
EB-00013
2) Apply grease to the sliding area of door hinges,
and install the door hinge to vehicle.
3) Install the front door to upper hinge and lower
hinge adjusting by jack.
4) Tighten the bolt of door checker.
5) Connect the door harness connector, and install
the instrument panel lower cover.
6) Install the front pillar lower trim.
EB-00014
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to EB-8, FRONT DOOR PANEL,
COMPONENT, General Description.>
EB-18
EB-00015
EB-00013